FAQ

|Air Cylinders

Is there a dedicated body for MY□ series cylinders with intermediate strokes or is the stroke adjusted with a spacer, etc.?

For MY1B/MY1M (W)/MY1C (W)/MY2C/MY3□ series cylinders with intermediate strokes, there is a dedicated body that can be made in 1 mm increments. The dedicated body for intermediate strokes used to be selectable for MY1H(T)/MY2H(T) series linear guide type cylinders by suffixing “-XB10” to the end of the part number. However, since August 2019, there is no longer a "-XB10" suffixed special order part number; it has been changed to the same part number as the standard stroke.

Note 1) The standard part numbers corresponding to 1 mm increments of the intermediate stroke lengths are shown below.
・MY1B/MY1M(W)/MY1C(W)/MY2C/MY3 series cylinders support strokes from 1 mm.
・ø16 to ø40 MY1H/MY2H series cylinders support strokes from 51 mm.
・MY1HT series cylinders support strokes from 201 mm.

Note 2) MY1H10 series cylinders support strokes from 60 mm in 10 mm increments for the standard part numbers.

Refer to the MY series catalog for details.
The MY□ series catalog can be found here.