FAQ

|Air Dryers

What is the evaporation thermometer on air dryers?

How should I select air dryers?

For IDF□□E and IDU□E series air dryers, are there terminal wiring and electric wiring diagrams for option “T” (with terminal block for operating, error, and remote operation signals)?

What is the evaporation thermometer on SMC air dryers used for?

For IDF/IDU series air dryers, is it OK to power down the dryer to prevent standby power?

Is it possible to view old air dryer catalogs to confirm the specifications? If so, where can they be viewed?

What is purge air in regards to IDG series air dryers?

What are the requirements for selecting an IDG series air dryer?

What does it mean when the color of an IDG series dew point indicator has changed?

How long is the maintenance cycle of IDG series air dryers?

What is the difference between the pressure dew point and the atmospheric pressure dew point for IDG series air dryers?

Can IDG series air dryers be unitized?

Can the new type of membrane module (IDG-EL□A) be used with an old IDG series air dryer?

Are there any compressed air requirements for IDG series air dryers?

How long does it take an IDG series air dryer to obtain the required dew point?

Can the purge air flow rate of an IDG series air dryer be adjusted?

Are the any measures that can be taken to prevent water droplets from being generated in the piping connected to a small cylinder?

What has been changed about the IDF□E/IDU□E series refrigerated air dryer auto drain? Also, are the new and old types interchangeable?

What can be done to prevent air from leaking constantly from the drain discharge part of an IDF□□E or IDU□E series air dryer with an auto drain?

For the IDF□□E and IDU□E series option “T” (*1), can remote control (operation start/stop) be performed by turning an external switch ON/OFF? Note 1) With a terminal block for operating, error, and remote operation signals

When replacing an IDF11C-1 with an IDF11E-10, is it possible to connect the air inlet/outlet to a bypass piping set to reduce piping work?