FAQ

|Air Dryers

When replacing an IDF11C-1 with an IDF11E-10, is it possible to connect the air inlet/outlet to a bypass piping set to reduce piping work?

If the previous type (IDF11C) did not use a bypass piping set, the IDF11E can be used with a bypass piping set (part number “IDF-S0184”), allowing for inlet/outlet piping width interchangeability.
If a bypass piping set was used with the IDF11C, the IDF11E can be with used with a piping set (part number “IDF-S0187”), allowing for inlet/outlet piping width interchangeability.
Since the dimensions from the bottom surface of the dryer to the piping port are different in both cases, it is necessary to adjust the height of the piping.
For details on the part number and dimensions, refer to “Optional Accessories” in the IDF series catalog.
The old IDF6D/8D/11C/15C series catalogs can be found here.
And the IDF6E/8E/11E/15E series catalogs can be found here.