FAQ

|Rotary Actuators

Is it possible to retrofit an angle adjuster unit to a CRB2 or CRBU2 series rotary actuator? If so, how?

Refer to the “Component Unit” section in the CRB□2 catalog for angle adjuster unit part numbers.
1 angle adjuster unit is required for retrofitting to an actuator without an auto switch unit.
When retrofitting to an actuator with an auto switch unit, 1 angle adjuster unit and 1 joint unit are required.
Sizes 20, 30, and 40 of the new CRB series released in November 2018 can be adjusted by ±5° on 1 side (start or end point) as standard.
The CRB□2 series catalog can be found here.
And the new CRB series catalog can be found here.